FRM220A-iMUX

Description The FRM220A-iMux is an E1 inverse multiplexer capable of bundling 4E1/ 8E1/16E1lines for cost-effective connection of 10/100Base-TX LANs over multiple E1 transports. The FRM220A- iMux transmits 7.93Mbps (iMUX4)/ 15.87Mbps(iMUX8)/ 31.74Mbps(iMUX16) Ethernet bridge channel (GFP-F encapsulated) over multiple E1 links. The FRM220A-iMux bridges the gap between E1 and E3, allowing bridgesto operate at faster rates. It also provides high speed access to SDH/SONET backbones where the only access services available are E1 lines. The FRM220A-iMux supports E1 attenuation of up to 43 dB on twisted pair or coax cable. This provides an approximate operating range up to 2km (using 22AWG). The FRM220A-iMUX fully comply the E1 specifications including ITU-T G.703 and G.823. The FRM220A-iMux features diagnostic capabilities for performing remote loopback The operator at either end of the line may test both FRM220A-iMux NTU and the line in the digital loopback mode. The Ethernet copper interface supports auto-negotiation and auto MDI/MDIX, allowing plug-and-play Ethernet connection without any additional configuration. Features The FRM220A - iMUX connects one Fast Ethernet over 1-4 E1 links (1.984Mbps to 7.93Mbps) for iMUX4, over 1- 8 E1 links (1.984Mbps to 15.87Mbps) for iMUX8, over 1- 16 E1 links (1.984Mbps to 31.74Mbps) for iMUX16 Built-in GFP bridge operates at WAN rate Maximum 220ms delay variance between E1 link Unbalanced E1/BNC or balanced E1/RJ45 Fully compatible with FRM220A chassis SNMP management with FRM220A chassis LED Alarm indication & Auto-Negotiation Standalone RS232 console management via CH01M for iMUX4/iMUX8, CH02M for iMUX16 Support MTU 1916 bytes.

NOTE: For more detailed information you may download the PDF datasheet below or you may contact us